Mint Tin Bike Light Continues

As the (normal) bicycling season draws to a close for my latitude, I’m nearing completion on my bicycle taillight project. I sent out a few weeks ago for some professionally fabricated pcbs and as usual, they look great. There were a few bugs that were entirely my fault, but nothing serious enough to stop the pcb from doing its job.

bicycle taillight pcb assembled

I added two “features” to the pcb before sending the design out, both of which were untested in the initial prototypes. The main feature I wanted to have was “motion detection”, so the taillight would shut down should the bike become idle for a period of time. No need to be wasting precious photons while the bike is leaned up against a tree or parked in a bike rack. Motion detection is provided by a roller ball switch, intended to replace the old fashioned mercury switch. A tiny gold plated ball rolls around in a plastic and metal cage, completing electrical circuits during its travel. The light’s micro-controller recognizes these impulses and continues to let the light function. As soon as the tilt switch stops changing state, resting as either a short or open circuit, the uC begins a count. When that count totals some arbitrary number, the light returns to a standby mode with the SMPS in shutdown. The uC then watches the tilt sensor for the state to change again and upon a change, resumes the previous operational mode.

The second feature is a battery minder circuit. Using a 2.5v precision reference, the micro-controller samples the battery voltage using its on board ADC. The idea is to detect a weak battery condition and operate the SMPS at a lower duty cycle, to make the most of the remaining power. The assumption here is that some light is better than no light in terms of safety. One of my pcb bugs lies in this circuit. The Microchip 12F683 uC I selected for this project is an 8 pin device. Its voltage reference pin is also multiplexed with the programming clock. In my design, I had made the error of connecting the vref pin directly to the voltage reference output, which is biased with a 1k resistor to the Vdd rail (bat +). So effectively, I have a very strong pull-up to 2.5v on that pin. This made programming the PIC impossible as it could not detect clock transitions. I will try salvaging these PCBs by changing to a 10k or 20k bias resistor on the reference, or cutting the trace leading to the Vref pin and soldering a 10k+ resistor in series, since we don’t need any current on that pin, just voltage.

Once I polish the code a bit more, I’ll be looking for a few folks to send a sample units to in exchange for reviews and feedback, down the road I would like to sell these either as a kit or a pre-assembled unit.

4 Replies to “Mint Tin Bike Light Continues”

  1. Nice project. About the 1K… can it be replaced wtih a 10K? Working with surface mount components is easier than you may think.

    Just put a blob of hot solder on both ends, remove the resistor with twezzers, clean excess solder with a copper strand and solder in a new 10K.

    sorry, i realize this is an old post.

Leave a Reply

Your email address will not be published. Required fields are marked *