Workbench Camera

Seeing a few other Makers add simple camera & boom systems to their workbenches, I was inspired to do the same. I tried to keep the construction as simple as possible.

Camera Boom Track

My boom track consists of two 3/4 inch floor flanges, two 3/4 inch 90° elbows, NPT on one end, slip fitting on the other and a five foot length of 3/4 inch schedule 40 pvc. The boom arm consists of a 1″ x 1″ x 1/2″ T fitting, cut in half, several random lengths of 1/2″ schedule 40 pipe, two 90° elbows and a end cap drilled and fitted with a 1/4-20 bolt, nut and wing-nut.

Camera Mount

Nothing is glued, so far friction holds it all together. I figure I can add set-screws if the elbows start to slip too much.

The camera is a Microsoft Lifecam Studio, which is a 1080p sensor with a fixed aperture auto focus lens. It’s a cell phone camera basically, when you get it to focus, it does a decent job. I’ve only recorded in 720p, I haven’t found the option to record video in 1080p, maybe my PC isn’t fast enough.

Leave a Reply

Your email address will not be published. Required fields are marked *